NC Hunt Lumber

An employee was attempting to start a loader. The loader rolled and struck the employee. The employee was hospitalized with seven rib fractures and a punctured lung.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.

An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.

An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.

An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.

An employee was operating a router when it cut his right little finger, causing an amputation through the bone.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.