American Railcars Industries

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was responding to a service request for a cable stripping machine that was making noise and not functioning consistently. While testing its function, the machine contacted the employee s right index fingertip, resulting in a fingertip amputation to the tuft.

An employee was using a handheld cordless electric torque wrench. The tool's reaction arm came into contact with the employee's left hand, causing an amputation to the middle finger above the first knuckle.

On August 6, 2025, an employee was preparing to weld a metal sheet that goes between containers and weighs 800 pounds. The employee was placing a two-foot wooden brace (4 by 4) under the metal, which was being raised by a crane operator using a magnet. The magnet shifted and caused the load to catch the employee's right index fingertip against the wooden brace, resulting in a fingertip amputation.

An employee was climbing up a ladder to the top of a railcar. The employee slipped and fell from the ladder, striking the coupler of the railcar during the fall. This caused the employee's body to shift, and they landed on their head/nose/face. The employee suffered broken ribs, a broken cheekbone, a broken nose, and internal bleeding.

An employee was climbing up a fixed ladder on a tank car. The employee fell from the ladder to the ground, 8 to 10 feet below, and broke both ankles.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.