Other fall to lower level, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Nabholz Construction, 1009 Wolfe St, LITTLE ROCK, ARKANSAS 72202
on — Fractures, affecting the wrist(s).
Final narrative
An employee was core drilling holes into a set of concrete exterior steps to make sleeves for the handrail. The drill bit became hung up, making the core drill twist and throwing the employee off balance. He fell off the side of the steps and landed on a concrete sidewalk, breaking his left wrist and landing on the side of his head.
An employee was sawing a notch into a cedar board with a chainsaw. The saw bound up and, when pulled free, struck the right side of the employee's chin. He suffered a laceration all the way to the cheekbone.
On 5/4/17, an employee was installing production equipment (conveyor) when the equipment fell 6 inches onto his left foot, breaking and lacerating it. He was hospitalized.
An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.
An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.
An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.