Struck by falling part of powered vehicle still attached · Dislocation of joints
At a glance
Federal OSHA recorded a severe workplace injury
at Performance Contractors, Inc., Shell Deer Park, DEER PARK, TEXAS 77536
on — Dislocation of joints, affecting the hip(s).
Final narrative
An employee was standing under a crane's boom while a coworker released the stow pin to disconnect a jib from the crane's boom. Once the coworker pulled the stow pin, the heavy side of the jib drifted down and made contact with the employee, dislocating his hip.
HospitalizedHip(s)Cranes-other mobile cranes
More severe injuries at Performance Contractors, Inc.
An employee was removing a 24" OD actuator valve that weighed 10,000 pounds from a structure on the fifth floor using a lattice crane. During the lift, the valve became hung up on the permanent handrail and their left thumb was caught between the valve and the handrail. The employee sustained a partial amputation of the thumb.
A crew was using a chain fall system to rig up a hard stop (metal structural support weighing 695 lbs.). The injured employee was guiding it into position. The hard stop shifted and their right hand was caught between the suspended hard stop and the adjacent structural wall, resulting in fractured ring and little fingers.
An employee was walking back from the tool room through the scaffolding material storage area. The employee's pant leg got caught on one of the 8-foot long scaffold planks that was in a scaffold rack. The employee tripped on the scaffold plank and fell forward, landing on his left elbow. The employee sustained a compound fracture to his left arm above the elbow and was hospitalized.
A crew was using rope to move a 24" diameter blind flange from the receiving deck of elevation 4 to a lower location so it could be more easily accessed by a crane. The rope broke and the blind flange fell 15 inches to the receiving deck of elevation 3, landing on the injured employee's feet. Both feet were fractured.
An employee was fixing a mechanical casket lift in a vehicle when the lift came down on their left-hand fingers, resulting in amputation of two fingers.
An employee was helping to remove the clamp attachment paddles from a forklift so they could then repair a hydraulic leak. The clamp fell and pinned the employee's right ring finger against the mast. The employee's finger was partially amputated.
An employee was on a truck attempting to stow an aluminum extension ladder onto the truck's conveyor boom system. As the conveyor mast was lowered, the boom control area came down on top of the employee's left foot, resulting in two toe fractures.
An employee was standing on the elevated forks of a forklift to install the fork chain anchor nut. The employee slipped and as he went to catch himself, he accidentally engaged the up-down control for the forks. This caused the forks to fall onto his foot. The employee's right foot was crushed and all of his right toes were amputated.
An employee was working on a scissor lift when a portion of the unit came down and struck their head at the lift base. The employee sustained a head laceration and a skull fracture.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.