HD Supply Construction Supply, LTD

A delivery driver was lifting bundles of wire mesh off a flatbed trailer using a truck-mounted lift. As he was lowering the mesh, the lift tipped over and ejected him forwards. He landed on the ground and was injured.

An employee was operating a bar bending machine when his finger was caught between the rebar and mandrel bender wheel, resulting in a right index finger amputation just above the first digit behind the fingernail.

An employee was bending rebar on a fabrication/bending machine when his right pinky finger was caught between the two ends of a piece of rebar as the ends overlapped to form a circle. The employee's fingertip was amputated.

An employee was walking to the front door, slipped on ice and fell to the ground resulting in injury to their left side.

While bending rebar, a piece of rebar sprung loose from the bending machine and struck an employee in the neck. The employee was hospitalized with a torn esophagus.

An employee was on a double-end rider in an aisle selecting product when his left leg was pinned between the rack and rider.

An employee was using a forklift to load a tractor trailer when the forklift skidded into a wall. The employee sustained an arm fracture.

An employee was training on an rolling container carrier on the dry, non-frozen storage side of the distribution center. She made a turn around the end cap and her right foot struck the rail protecting the endcap racking. The employee's foot was fractured.

An employee was a passenger in a utility vehicle that was driving up a hill on a wooded trail. As the vehicle made a right turn, three fingers on the employee's right hand were caught against a tree and fractured.

An employee was operating a forklift when his left leg was caught between the forklift and a bollard resulting in a broken leg.

An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.

An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.

An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.

An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.

An employee was operating a router when it cut his right little finger, causing an amputation through the bone.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.