Riverview, LLP

An employee was setting a roof truss when their thumb became trapped between the roof truss and the steel plate. The distal phalanx of the thumb was surgically amputated.

An employee was in a feedlot pen helping a coworker with a steer that was having problems getting up. The coworker was behind the animal and the employee was at its head, attempting to move it. After he moved the steer's head, the animal tried to get up. As it was trying to stand, the steer swung its head and hit the employee's lower right leg, fracturing his tibia.

An employee was preparing to euthanize a heifer using a captive bolt gun. He armed the captive bolt gun and repositioned himself for better footing. When he fired the stunner, the gun shot into his right hand and wrist, causing tendon and nerve damage that required hospitalization.

On November 16, 2023, at around 3:30 p.m., a subcontracted employee was painting a door jam on a three-story house when he fell 20 feet through an opened elevator shaft to the floor below. The employee sustained fractured vertebrae that required hospitalization.

Employees were removing and replacing skylights on a metal roof. The injured employee's lanyard became tangled and they fell through the skylight to the ground 16-18 feet below. The employee suffered fractures to the wrist, ribs, and hip.

An employee was requested by a client to string wire on top of an auditorium. He used a boom lift to access a beam and then exited the boom lift to walk on the beam. He then stepped down on a drop ceiling, lost balance, and fell. The drop ceiling caved in and the employee fell 20 feet onto bleachers sustaining injury to his abdominal area and lower left leg. The employee was wearing a harness, but it was not connected to an anchoring point at the time of the fall.

An employee was installing decking (steel grates) in a new construction steel framed building. The employees were working approximately 22' above the next lower level, which was a concrete ground floor. The decking was pre-cut with the floor opening prior to installation. Shortly after installing the floor opening, the employee fell through the floor opening, approximately 18' onto a section of metal ductwork, resulting in fractures to the skull, ribs, thorax, and lumbar vertebra, as well as an ear laceration.

An employee was taking measurements of an area for drywall when they stepped backward into a partially covered hole in the floor. The employee fell approximately 17 feet to the level below, sustaining a forehead fracture and avulsion, a right shoulder dislocation, a left forearm fracture, left knee tendon and meniscus tears, as well as multiple contusions and abrasions.

Employees were stripping parts off an old pivot. An employee was standing on the ground, helping others make sure that the parts all came off the pivot. The pivot span was elevated when the base beam broke free on one side. This shifted the weight of the span, causing it to roll off the loader on its side. When the span came down, the support rod caught the employee's back as he went to turn and run away from it. It pushed him to the ground. He suffered a back fracture, along with a broken bone in his foot, and was hospitalized.

An employee was walking through the hospital pen and a cow struck him with her head. The employee sustained an orbital fracture.

An employee was working in a holding pen, using a crowd gate to herd cows into milking stalls. She was moving to beat the crowd gate to a manhole, but the gate moved and struck the employee. The employee was hospitalized with two fractured processes in her lower vertebrae.

Three maintenance employees were working on chemical lines feeding into a large above ground wastewater treatment tank. Sodium hydroxide and sulfuric acid reacted in a floor drain and the chemicals sprayed onto the three employees. One employee was taken to the hospital for burns to his eyes.

An employee was removing a pin from a metal gate to let cows out of a parlor. The gate moved and his left middle finger was caught in the pin hole. The employee's finger was partially amputated.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

A skid loader backed over an employee's leg, breaking it.

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.