Goodyear Tire and Rubber Company

A tire fell behind the press. An employee was attempting to remove the tire from behind the press when the tire became caught between the mold can and guarding. Another employee lowered the mold can which caught the end of the injured employee's boot between the upper and lower mold rings, resulting in an amputation of four toes on the right foot.

An employee was repurposing a damaged flammable cabinet into a locker for their tools. They had the cabinet standing up with two non-rotating casters in place and went to pick it up so they could set it on a block in the upright position to work on the shelves when the cabinet shifted and fell on their right middle finger, resulting in a fingertip amputation.

An employee was operating a wire calender machine and was trying to remove rubber off the impression roll when they were contacted by the wire going over the impression roll. The ring and little fingers on his right hand were amputated, and the middle finger was partially amputated at the middle knuckle.

An employee was feeding rubber into the feed tray. While aligning the rubber, the employee's hand became caught by the screw resulting in amputation below the elbow.

An employee was performing training tasks on the bead unit. A bead wire began to wrap around the drum so the trainer cut the wire and reclosed the interlocked gate. The injured employee/trainee then went to clear the wire that was hanging from the drum and had their finger pinched between two of the chucks, resulting in a left index fingertip amputation.

Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.

An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.

An employee was being trained on a machine when a roller came down on their hand, resulting in a fracture and laceration.

An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.

An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was adjusting a pallet on a conveyor when it came off the conveyor and struck his right ankle, breaking the tibia and fibula. The employee was hospitalized.

At 2:45 p.m., an employee was outside the plant during a break before his next shift. He was speaking with an associate when he suddenly fell from the third-level steps to the ground, striking his head on the concrete. The employee was hospitalized due to internal brain bleeding, a wound to the back of his head requiring staples, and heat-related dehydration.

Two employees were replacing a motor on an overhead conveyor. The old motor fell to the floor, causing a piece of the concrete floor to fly up and strike the injured employee in the face, around the eye. The injured employee sustained a right orbital fracture, a zygomatic arch fracture, and a sphenoid fracture. The employee was hospitalized and required surgery.

An employee was changing the bladder on a hydraulic press. As he lowered the bladder, his left foot was pinned between its bottom ring and the bottom mold of the press. The second toe on the foot was amputated.

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.