Federal OSHA recorded a severe workplace injury
at Case New Holland Inc., 600 E. Peoria St. , GOODFIELD, ILLINOIS 61742
on — Amputations, affecting the fingertip(s).
Final narrative
On April 17, 2017, an employee was using a stand-up tugger to move a cart to a staging area when his right index finger was caught between the light pole on the tugger and a frame that was on the cart that he was moving resulting in the amputation of the right index fingertip.
An employee was using a dozer to clear a plot of land. The dozer struck the ground after getting stuck on a tree stump, causing the employee to hit their head on the cab roof. The employee sustained a spinal compression injury.
On August 31, 2023, an employee was operating an excavator to complete a demolition job. As the excavator drove into the first floor of the building, the floor collapsed. The vehicle and employee dropped approximately 8 feet, causing the employee to sustain a back injury.
An employee was standing on a walk-behind lawn mower when the mower spun out of control. His right ring fingertip became caught in the handlebar, resulting in an amputation.
An employee was loading a bundle of 3/8-inch rebar using a standup skid loader. While transporting the load, the equipment tipped forward, throwing the employee over the controls and into the mast of the skid loader. The employee sustained several teeth avulsions, a mouth laceration, and bruising/swelling around the face.
An employee was driving a forklift to deliver lumber to a work site when the forklift tipped forward onto the forks. The employee struck his head on a metal railing on the forklift, resulting in a laceration, a concussion, and temporary loss of consciousness.
More severe injuries in this industry (NAICS 333111)
An employee was climbing up a fixed ladder alongside a building to inspect a roof leak. The employee fell off the ladder and landed on the ground about 15 feet below. The employee was hospitalized with fractures to both wrists.
On September 16, 2025, an employee went to pull a weld stand when he tripped and fell, landing on the floor on his right hip. The employee suffered hip and fibula fractures that required hospitalization and surgery.
An employee was accessing a tensioned hook that required a hoist mechanism to be engaged. He was unhooking the lift hook from a shelf column when the "up" button was pressed, which released the tension on the pneumatic air hoist. The employee's right index finger was caught between the hook and the column, resulting in a soft tissue amputation and fracture to the fingertip.
A crane was lifting a pole out of a zinc bath in the galvanizing department when the chain attached to the pole broke. The pole fell back into the bath and liquid zinc splashed onto an employee, who suffered third-degree burns to an arm, the abdomen, the torso, the upper left side of the chest, an ear, the neck, and a hand.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.