120 85, LLC

An employee was being trained to operate a yard truck to move trailers in and out of docks and to place them in storage areas. The employee was standing inside the yard truck cab as the trainer demonstrated how to operate the yard truck. As they performed a tug test, the truck jolted forward, causing the employee to sustain a lower back strain. The employee experienced numbness of the toes, bilateral leg weakness, and back pain that required hospitalization.

An employee was in a boom lift when the vehicle struck a hole then stopped abruptly. The impact ejected the employee and his fall protection pulled him back into the basket. The employee possibly struck the basket and was hospitalized for a leg fracture that required surgery.

An employee was operating a three-wheeled forklift to hoist metal material with a sling system. While driving downhill in a gravel driveway, the front tire caught a root and the forklift lost momentum. This caused the hoisted material to sway and the forklift tipped forward. Inside the forklift, the employee struck against the dash and roof of the cage, sustaining a contusion to the forehead, abrasions to both legs, and later had a seizure.

An employee was moving gravel with a skid steer. The skid steer lunged forward and the employee fell backward. The employee's feet were caught between the standing plate and the framing above it, and both ankles were broken.

An employee was moving a bulldozer from one portion of the site to another. The bulldozer traveled over a mound of dirt. The blade got caught in the dirt on the opposite side of the mound and the dozer came to a sudden stop. The driver was propelled out of his seat and his head struck the top of the cab. The employee suffered two fractured vertebra and weakness in his right hand and leg.

An employee was stopping traffic at a job site so a piece of equipment could be moved to another location when he was struck by a car. It sent him in the air and he landed on his back, resulting in hospitalization with five fractured ribs, a fractured forearm, and a liver injury.

A truck of asphalt binder was being unloaded. An employee was checking the transfer hose connection on the truck. The gasket on the hose blew out, causing the asphalt binder to shoot out and burn the employee's face, neck, and arms.

A truck driver was on a platform, pulling a tarp on an asphalt load in a six-wheel dump truck. He fell from the platform to the ground and suffered broken ribs.

An employee was using a cutting torch to heat up bolts that had seized up. The bolts caught on fire in a flash burn, and the employee suffered burns to the arms and elbows.

On May 15, 2025, an employee was cutting down steel mesh and debris that was protruding from a milled roadway. As the employee began to cut a piece of steel with an angle grinder, he steadied himself with his left hand and the tool contacted the top of his left wrist, resulting in a laceration that required hospitalization.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.