CHAPMAN CONSTRUCTION

An employee was removing grounds when he was electrically shocked by induced voltage coming off an existing 138 KV line.

An employee was unloading poles and was pinned to the ground when a pole rolled off of the fork truck, suffering a right leg injury.

An employee was caught between a utility pole and a truck, fracturing a leg.

An employee was unloading steel poles from a trailer. The employee was on the trailer during the rigging, trying to locate the center gravity of the poles. Once he located the center gravity, he went to the other side of the trailer to get off. He lost his balance, slipped, and grabbed one of the rebar supports on the trailer. At that time, the operator began lifting the pole upward. As the pole was lifted, it swung toward the injured employee and caught his right hand between the rebar support and the steel pole. His right middle fingertip was amputated and his right index finger was lacerated.

An employee was making modifications to an electrical panel when an arc flash occurred. The employee suffered burns to multiple parts of the body.

An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.

An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.

On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.

An employee had just turned off breakers and was loosening wires on panels when they were shocked by 480 volts of electricity.

An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.

An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.

An employee was working to move a telephone pole when the pole rolled, causing injury to their hip.

An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.