R K & S CONSTRUCTION OF THE FLORIDA KEYS, LLC

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An excavator bucket was being removed. An employee was pulling a snap ring to remove a pin and lost his grip. The high-tension snap ring recoiled and his left middle fingertip was amputated by the snap ring.

An employee was walking between service bays. He came into contact with a trailer hitch, which was sticking out of the back of a lawn mower, and fell to the concrete floor. He landed on his right side and suffered a broken hip.

An employee was taking a scissor lift off a flatbed trailer. While using the remote operator controls and walking alongside the lift, the wheel of the lift turned in the wrong direction, causing it to strike the employee and roll over his left ankle. The employee was hospitalized with two broken bones in his ankle.

An employee was working on an excavator's tracks. He was swinging a sledgehammer to finish pushing a metal tractor pin into the track links. A hammer-blow caused a piece of the pin to fly off, ricochet, and embed itself in his buttock. He was hospitalized, requiring surgery.

An employee was picking up crane pads to put onto their trailer. Their finger got pinched between pads, resulting in an amputation involving the loss of skin.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.