Active Power Inc.

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee turned a corner while walking, tripped over the corner of a pallet on the floor, fell onto her arm, and broke it. She was hospitalized, requiring surgery.

An employee was moving a transformer from inside a shop. He was rolling it down a ramp when it tipped over onto his right foot and big toe, resulting in crush injuries and a laceration.

Employees were moving an electrical cabinet by using two wheeled equipment skates. One of the wheels of the skates became caught in a crack in the floor, causing the equipment to tip over and land on an employee's right foot. The employee's foot was fractured.

An employee was using an industrial magnet to lift and maneuver a weldment. While the frame was being set down on the welding table, the magnet disengaged prematurely; the frame fell and crushed the employee's left ring and middle fingers. The employee underwent medical amputations to the middle finger (at the first knuckle) and the ring finger (just past the second knuckle).

An employee was working on an order when they were struck by a forklift. This caused the employee to bump into a machine. The employee suffered a laceration to the right thigh, requiring hospitalization.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.