TCC Materials, LLC

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

After clearing a plugged cement feed chute underneath a silo, the injured employee asked a coworker to "bump" the rotary feeder to confirm material flow had resumed. The rotary feeder's inspection port was open, and dust was escaping until the injured employee covered the hole. Material then built up and prevented a visual inspection inside the feeder. The injured employee then instructed the coworker at the operating switch to stop the machine. While the feeder was still rotating due to inertia, the injured employee pushed the packed material out of the inspection port. A rotating blade partially amputated their right index fingertip.

Liquid concrete was being unloaded from a ready-mix truck into a mobile dump buggy. An employee was holding the truck s chute handle while standing beside the buggy. As the dump buggy moved forward, the employee s fingertip was caught and pinched between the chute handle and the buggy s bucket. The left ring fingertip was amputated.

At approximately 3:30 PM, on 4/30/2025, a Quikrete employee was exiting a tractor trailer when he slipped and fell to the ground. The employee sustained a fractured left femur.

An employee was utilizing a 10-foot fiberglass ladder to install an antenna on the side of a one-story residential home. The height of the mounted antenna from the ground was approximately 12 feet. While completing the installation of the antenna the employee lost his balance and fell approximately 8 feet to the concrete below, resulting in two fractured heels.

An employee was on a flatbed straightening return pallets when they sustained a back injury.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

A skid loader backed over an employee's leg, breaking it.

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.