Fall from collapsing structure or equipment 16 to 20 feet · Traumatic injuries and disorders, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Elite Industrial Painting Inc, Bridge C - #17534, Hwy 69, DURANT, OKLAHOMA 74701
on — Traumatic injuries and disorders, unspecified, affecting the nonclassifiable.
Final narrative
An employee was removing fence pieces (platform). He was standing on a smaller fence piece and cut the rope from a large section of fence piece. The large section came loose and the smaller section gave way. He fell approximately 20 feet to ground level (roadway). His PPE was not tied off at the time.
An employee was on top of a 2-by-4 purlin installing rafters. The purlin broke and he fell to the ground about 16 feet below, suffering a broken left femur.
An employee was working in a boom lift to help tear down a building. The employee stepped out of the boom lift and onto one of the trusses when the building collapsed, causing the employee to fall approximately 17 feet to the ground below. The employee sustained fractures to the wrist, hand, ribs, and face.
An employee was climbing a power line pole when the pole broke at ground level while the employee was approximately 20 feet up. The employee rode the pole to the ground and sustained 12 broken ribs, a broken collarbone, and a punctured lung.
An employee was on a pallet that was being lifted by a forklift to a height of 20 feet. The pallet broke and the employee fell to the warehouse floor sustaining fractures to their nose, ribs, and ankle.
An employee was performing tuckpointing while on a swing-stage scaffold. The rope on the scaffold broke and the side of the scaffold fell 20 feet to the ground. The employee impacted the ground and sustained a broken ankle that required hospitalization and surgery.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.