Cargill, Inc.

An employee was conducting preventive maintenance on a decline conveyor, spraying lubricant on its tension rollers, when his left arm was caught by the conveyor system and pulled between the roller and the belt. He suffered a fracture to the wrist and two fractures to the forearm.

An employee was bringing a filter online. When the employee opened a valve to initiate flow through the filter, the gasket on the filter housing failed, spraying a water/erythritol mixture (heated to about 175 degrees Fahrenheit) toward the employee. The employee moved back quickly and their chemical suit caught on something, causing it to open. The mixture burned the employee's abdomen and left arm.

An employee was replacing the exhaust fan above the scalding area when their finger became pinched in the exhaust fan shroud. The employee sustained amputation of the distal tuft of their right middle finger with bone loss.

On July 17, 2024, an employee was trying to retrieve his knife from the bottom of a sterilizer. Water in the sterilizer, heated to 180 degrees, entered the employee's right glove and burned his palm and the top of his hand. He was hospitalized.

An employee was waiting for the elevator to get to the floor that he worked on. The employee went to step through the elevator door, but the elevator lift was not there, causing him to fall 20 feet to the basement below. The employee sustained fractures in both legs, the right heel, and lower vertebrae. He was hospitalized.

On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.

An employee was examining a machine when a part moved up and amputated a fingertip on their left hand.

An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.

An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.

An employee's right hand was caught in a wire drawing machine, resulting in amputation.

An employee was scraping dried glue from the top lid of a hot glue pot. His left hand slipped and came into contact with the hot glue. He then suffered burns to his hands and fingers as he tried to remove the glue. He was hospitalized.

An employee was in a scissor lift approximately 20 feet above the ground to place a plastic tarp on a catwalk in order to catch condensation. They positioned the lift opposite the work area and stepped out of the scissor lift onto an I-beam. The employee fell from the I-beam to the ground. The employee was hospitalized with a skull fracture on the right side of their head and injuries to the chest and both eyes.

A maintenance employee was called to look at a pallet conveyor machine where a chain had fallen off a sprocket wheel. When the employee grabbed the loose chain, a light sensor caused the machine to restart. This created a pinch point between the chain and sprocket that caught the employee's left little finger. The finger was surgically amputated at the second knuckle.

The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.

An employee was using a box strapping machine to place straps on boxes when his right middle finger was caught in the machine, resulting in an open fracture to the distal phalanx.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.