Cargill, Inc.

An employee was conducting preventive maintenance on a decline conveyor, spraying lubricant on its tension rollers, when his left arm was caught by the conveyor system and pulled between the roller and the belt. He suffered a fracture to the wrist and two fractures to the forearm.

An employee was bringing a filter online. When the employee opened a valve to initiate flow through the filter, the gasket on the filter housing failed, spraying a water/erythritol mixture (heated to about 175 degrees Fahrenheit) toward the employee. The employee moved back quickly and their chemical suit caught on something, causing it to open. The mixture burned the employee's abdomen and left arm.

An employee was replacing the exhaust fan above the scalding area when their finger became pinched in the exhaust fan shroud. The employee sustained amputation of the distal tuft of their right middle finger with bone loss.

On July 17, 2024, an employee was trying to retrieve his knife from the bottom of a sterilizer. Water in the sterilizer, heated to 180 degrees, entered the employee's right glove and burned his palm and the top of his hand. He was hospitalized.

On May 11, 2023, at 8:15 PM, an employee was unloading a railcar. The car had been steamed and the top was vented. The employee connected the unload hose to the bottom of the car and when the railcar valve was opened to begin the unload process, pressure from the unload piping surged back into the railcar. This caused 200-degree F oil to spill out of the top of the railcar, contacting the employee.

An employee was transitioning from a ladder onto a roof when the ladder slipped and they fell approximately 20 feet to the ground. The employee was hospitalized with fractures to their pelvis and heel.

An employee was tearing down shingles when they fell approximately 18 feet from a roof to the ground, sustaining a broken ankle.

An employee was climbing a ladder to bring material onto a roof. The ladder slid and the employee fell 16 feet to the ground, resulting in a broken knee.

An employee was performing an inspection of a bridge crane while working from a 19-foot scissor lift. The employee was going to use a pendant to move the crane to access a different portion of the crane for visual inspection. The scissor lift guard rails were below the girder of the crane to avoid contact. The tow arm for the crane collectors contacted the guardrail of the scissor lift and caused it to tip over. The employee stayed inside the scissor lift basket as he fell to the floor. The employee sustained fractures to the right arm and hip.

An employee was on a forklift that was elevated approximately 20 feet and was auditing inventory. The forklift malfunctioned and the employee fell down to the surface below, causing them to sustain multiple fractures.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.

An employee had been cleaning a grain bin. He walked across the bin and his left foot contacted an unguarded floor auger, resulting in severe lacerations to the foot. The auger was not locked out/tagged out at the time.

On September 23, 2025, an employee was monitoring a feed roller when they tripped and their right hand contacted the roller. The employee was hospitalized and their right hand was amputated at the wrist.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.