Dresser-Rand

An employee was using a pneumatic chipping gun to demolish a concrete foundation when the chipping gun fell from the employee's hands. As he tried to catch it, he fell 8 feet to the ground, suffering fractured vertebrae and a head laceration.

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

An employee was spotting a crane when the load (fabricated skid for packaged equipment) that was being picked up came loose and fell on the employee. The employee sustained a crush injury resulting in a fractured pelvis.

An employee was setting up dies on a die casting machine. The machine's ram unexpectedly returned from the down position and caught the tip of the employee's right thumb against a pinch point in the shot sleeve. The employee suffered an open fracture/amputation to the thumb tip. The machine was not locked out at the time.

Employee 1 was cleaning a paint gun using paint thinner when employee 2 started a lighter nearby and the cup of paint thinner ignited. Employee 2 dropped the cup and the ignited paint thinner spilled, causing burns on employee 2's arms, legs, hands, and face.

An employee was installing a part using an aerial lift and a ratchet. The lift rose and crushed his left thumb.

An employee was servicing a reciprocating air compressor when their left middle finger was caught in a belt motor pulley sheave while manually moving the belt. Approximately 1/4 inch of the employee's left middle fingertip was amputated.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.