MOLDED ACOUSTICAL PRODUCTS OF EASTON, INC.

During an attempted robbery, an employee in the parking lot was shot twice. The employee sustained bullet wounds to the shoulder and leg.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was operating a machine and went to remove a buildup of desiccant from the machine. Their right index finger was pinched between two moving parts, resulting in an amputation to the finger.

On September 3, 2025, an employee was working on the left-side charger of a tank. They were using a ratchet with an extension to make an adjustment to the sand seal when their right thumb was pinched between the ratchet and the running charger, resulting in an amputation at the first knuckle.

A forklift was placing an elevated load onto a truck. The forklift tipped forward and fell on the injured employee who was standing nearby. The employee sustained fractures to their hip and ribs, as well as leg muscle injuries.

At 12:09 p.m. on July 11, 2025, an employee was inspecting the dust collection system in a plant. The employee was checking an airlock to determine whether there was suction when their left index and middle fingers were pinched between the rotating rotor and the housing of the airlock. The employee suffered amputations of both fingertips without bone loss.

An employee was manually removing a bearing from a vertical washer brush. Due to the weight of the brush roll, it released and crushed his left ring fingertip resulting in amputation without bone loss.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.