Jet Stream Guttering Corp.

An employee was transitioning from a ladder onto a roof when the ladder slipped and they fell approximately 20 feet to the ground. The employee was hospitalized with fractures to their pelvis and heel.

An employee was tearing down shingles when they fell approximately 18 feet from a roof to the ground, sustaining a broken ankle.

An employee was climbing a ladder to bring material onto a roof. The ladder slid and the employee fell 16 feet to the ground, resulting in a broken knee.

An employee was performing an inspection of a bridge crane while working from a 19-foot scissor lift. The employee was going to use a pendant to move the crane to access a different portion of the crane for visual inspection. The scissor lift guard rails were below the girder of the crane to avoid contact. The tow arm for the crane collectors contacted the guardrail of the scissor lift and caused it to tip over. The employee stayed inside the scissor lift basket as he fell to the floor. The employee sustained fractures to the right arm and hip.

An employee was on a forklift that was elevated approximately 20 feet and was auditing inventory. The forklift malfunctioned and the employee fell down to the surface below, causing them to sustain multiple fractures.

An employee was using a 10-foot step ladder to install roller shades. The employee fell from the third rung from the top, landing on the ground and suffering back and head injuries. The employee was hospitalized.

An employee was climbing a ladder to access a home attic. The employee fell from the ladder to the ground, suffering a broken right elbow.

An employee was cutting a cast iron pipe when the pipe fell onto his right hand, resulting in amputation of the thumb. The employee was hospitalized.

While on a scaffold, an employee was transporting heated sealant material in a bucket. The employee tripped and fell, causing the heated material to splash onto his gloved hands. The employee sustained second-degree burns to both hands and his right wrist.

Three employees were pulling tension cable (similar to rebar) through the walls of a condo using a motor system. Two employees were needed to hold the cable while the third employee drilled the mounting locations. When the third employee activated the drill, the cables twisted. They caught the right index finger of one of the other two employees, amputating his fingertip.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.