Injured by slipping or swinging object held by other person · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Simon Contractors, 20525 Riverside Drive, STERLING, COLORADO 80751
on — Amputations, affecting the fingertip(s).
Final narrative
On 4/02/2018, employees were replacing a pin in the chain for a slat conveyor. The sledge hammer used to pound the pin into the chain missed the pin and struck the left pinky finger of the employee who was holding the pin. The employee's fingertip had to be later amputated.
An employee was standing on the second step of a step-ladder unhooking a 4-inch hose. After unhooking the hose, the end of the hose caught his glove pulling the employee off the ladder to the deck two feet below the ladder. The hose continued to pull the employee to the ground approximately 2.5 feet below the stepladder. The employee suffered neck trauma and spinal cord swelling.
A backhoe operator was exiting the cab of the backhoe when his wedding ring got caught in the door handle. When he stepped down, the momentum caused injury to the left ring finger that required partial amputation at the hospital.
The injured employee was holding a board that was being cut by another employee. The board kicked back, causing the saw to amputate the employee's left little finger and lacerate their left hand, resulting in nerve damage.
On September 26, 2023, an employee was working in a trench box while a co-worker was lowering a piece of plastic pipe by hand using a rope. The pipe swung and struck the employee's hand, fracturing their right thumb and middle and ring fingers. The employee was hospitalized.
An employee went over to a co-worker's station while the co-worker was using a powered meat knife. As the injured employee was pointing, his right index fingertip was amputated.
Two employees were using a handheld banding tool to make banding tape for tent set-ups. One employee was holding the banding tool and the injured employee was looping a metal clip around the tape. The tool closed while the injured employee's hand was near the banding mechanism. The banding tape caught the employee's right ring finger as it tightened, resulting in a partial amputation.
An employee was holding a branch against a log on the ground to make a wedge while another employee was using a chainsaw to cut the wedge. The saw slipped and struck the employee holding the branch, resulting in a laceration to the right wrist.
More severe injuries in this industry (NAICS 324121)
An employee was stopping traffic at a job site so a piece of equipment could be moved to another location when he was struck by a car. It sent him in the air and he landed on his back, resulting in hospitalization with five fractured ribs, a fractured forearm, and a liver injury.
A truck of asphalt binder was being unloaded. An employee was checking the transfer hose connection on the truck. The gasket on the hose blew out, causing the asphalt binder to shoot out and burn the employee's face, neck, and arms.
A truck driver was on a platform, pulling a tarp on an asphalt load in a six-wheel dump truck. He fell from the platform to the ground and suffered broken ribs.
An employee was using a cutting torch to heat up bolts that had seized up. The bolts caught on fire in a flash burn, and the employee suffered burns to the arms and elbows.
On May 15, 2025, an employee was cutting down steel mesh and debris that was protruding from a milled roadway. As the employee began to cut a piece of steel with an angle grinder, he steadied himself with his left hand and the tool contacted the top of his left wrist, resulting in a laceration that required hospitalization.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.