Scot Industries, Inc

An employee hooked up two bundles of steel tubing to be lifted with an overhead crane. He stumbled while walking and operating the crane and his right hand contacted the crane's pulley mechanism. The upward motion of the crane caused the cable to pull his finger into the pulley. The employee's fingertip was partially amputated.

An employee was pulling a piece of square bar (weighing about 354 pounds). The bar slid and pinched the employee's right middle fingertip against another bar, causing an amputation (as well as a laceration and fracture) to the fingertip.

An employee was pulling a nylon sling up from between loose pieces of material in a bundle cart. The bundle cart tipped over, and seven loose pieces of tubing fell from it to the ground about 30 inches below, then rolled into the employee's left ankle/foot. The employee was pinched between the tubing and a stack of material.

An employee was using an overhead crane to move steel tubing when one stack of tubing fell and struck the employee. The employee was hospitalized with a fractured left leg.

An employee was cleaning their hands with a shop rag and got a steel splinter in their hand. The splinter required surgery.

An employee was tossing a damaged toilet into a compactor. The toilet bounced off the compactor and lacerated the employee's right wrist, cutting an artery and tendon.

An employee was operating a hydraulic jack to bend a frame when the jack came loose and struck the employee. They were hospitalized for a spleen injury.

A truck had been towed into the shop with a flat tire and a blown airbag. An employee checked the tire for damage and was airing the tire. The employee was installing the valve core when the bead slipped off the rim. Air escaped, and the aluminum wheel struck the employee's head and face. The employee became unresponsive and was bleeding.

On December 14, 2023, at 8:40 p.m., three employees were inspecting milling machines for startup. A few of the sleeves on the mill drum needed to be changed out. The injured employee was trying to input a sleeve on the mill drum using a hammer. The hammer hit the edge of the drum, which caused a metal piece to splinter off and strike the employee's cheek just below the left eye. The metal splinter embedded in the back of their eye socket, resulting in pain, swelling, and bleeding that required hospitalization.

An employee was pushing a line of carts into a vestibule when the door cable snapped and struck his right ankle. The employee suffered a fracture that required surgery and hospitalization.

An employee fell onto a hot billet and suffered a burn to the left leg. The employee was hospitalized.

An employee was cutting wooden boards using a table saw when the glove on his left hand was caught by the blade, resulting in a partial fingertip amputation.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

A crane was hoisting a pipe. An employee was adjusting twisted lifting chains on the end of the pipe when the pipe was raised, causing the employee's hands to be caught between the chains and the pipe. The employee suffered injuries to the left index finger, left ring finger, right ring finger, and right index finger; the right index fingertip was amputated without bone loss.

During a routine inspection, an employee placed their hand on a pipe to check a weld. The pipe clamp activated, closed on the pipe, and trapped the employee's right middle finger, resulting in a partial amputation and fracture to the fingertip as well as a laceration to the ring finger.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.