Delphinus Engineering Inc

An employee sustained an electrical shock while performing stick welding, resulting in an arrhythmia.

On July 17, 2018, an employee was working in an elevator platform when one of the hoist sheaves suddenly rotated and hit him in the head. It then returned to its original position, knocking off his hardhat and lacerating his scalp.

An employee was moving a dock with another employee when his hand was caught between the dock board and a pipe, incurring severe lacerations that required hospitalization and surgery.

An employee was replacing the rubber gasket on a dredge boat's discharge pipe. The dredge boat was moving with the waves, which pushed the dredge pipe into the pontoon of the boat. The employee was holding the end of the dredge pipe when it struck the pontoon of the boat. The employee's right index finger was caught between the end of the pipe and the pontoon, resulting in a fingertip amputation.

An employee was loading cargo ship containers when he was caught between two cargo ship containers, resulting in a broken arm and ribs. He was hospitalized.

An employee was traversing on deck when the dredging boat was involved in an accident. The employee suffered a broken nose.

An employee was walking off a ship when he slipped on the accommodation ladder and twisted his left leg. He was hospitalized for surgery.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.

An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.

An employee was descending a ladder carrying a bag of trash. He fell, landed on the ground about 10 feet below, and suffered fractures to his right hip and pelvis.

The injured employee was assisting a Department of Homeland Security (DHS) enforcement operation. During an apprehension, officers returned fire at a subject and struck the employee with a bullet. The employee sustained a gunshot wound to their right hand.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

An employee was working on an electrical panel in a mechanical room when an arc flash occurred. The employee suffered burns.

At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.

An employee was preparing a bundle of green onions for chopping. While holding the bundle in his left hand, he made his first cut using a 9-inch kitchen knife held in his right hand. The knife contacted the tip of his left thumb, resulting in an amputation of approximately 0.5 inches of the thumb that required hospitalization.