Struck by object or equipment dropped by other person · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at FCMP INC., 230 Fire Tower Drive, TONAWANDA, NEW YORK 14150
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
Two employees were changing the filter in the parts washer. The injured employee was lifting the metal basket out of the housing with another employee. It slipped out of the second employee's hands landing on the pinky finger of the injured employee. The finger was amputated.
AmputationFinger(s), fingernail(s), n.e.c.Machine and appliance parts, n.e.c.
The injured employee was standing at the base of a ladder assisting another employee install a TV on a wall. The TV was dropped, striking the employee. They sustained a head injury.
An employee and a colleague were moving two pieces of rebar when a tie was cut. The employee holding the rebar dropped it while it was above the injured employee's hands, resulting in partial amputation to their left middle finger.
An employee was bracing an extension ladder while his coworker installed a 10-foot, 40-45-pound pipe. The pipe fell onto the injured employee's head and he sustained a hematoma, C3 and C4 vertebral fractures and a forehead laceration.
An employee was helping to lift a press roll in to fix an issue that was occurring. A co-worker lost their grip and the press roll fell onto the injured employee's left index finger, resulting in a crush injury and amputation.
Three employees were removing equipment from an old fermentation room at a bakery. They were using two bakery dollies to remove metal plates from the floor of the room. One of them was holding one of the metal dollies with his right hand on the side of the dolly, as a plate was being centered on the two dollies. The plate slipped and struck his right thumb, which was amputated near the last joint.
More severe injuries in this industry (NAICS 336390)
An employee was changing out the sensor wire on a sensor cap press. The machine actuated after the sensor was replaced, resulting in the amputation of the employee's left little finger.
A temporary employee was working on a plastic extrusion machine. The employee's left index finger got caught between the rotary gears, resulting an amputation to the finger.
An employee in the warehouse area was operating a semi-automated machine and noticed that the machine was not operating properly. He went to use a paper towel to clean the main rollers and his left hand was caught by the rollers. Two fingers were crushed.
An employee was walking to collect trash from a box at a work cell parts stand. A leg of the stand caught the employee's foot, causing the employee to lose balance, fall to the floor, and suffer a broken left elbow.
An employee's leg became entangled in a printer power cord. As she stepped backward, she got hung up and fell. She landed on her right side and suffered a broken right hip.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.