Overexertion in lifting-single episode · Herniated discs
At a glance
Federal OSHA recorded a severe workplace injury
at Terex Utilities, Inc., 1901 14th Avenue NW, WATERTOWN, SOUTH DAKOTA 57201
on — Herniated discs, affecting the back, including spine, spinal cord, unspecified.
Final narrative
An employee was assisting others in a team lift effort to put a large bumper into the back of a truck and suffered a herniated/ruptured disk requiring surgery.
HospitalizedBack, including spine, spinal cord, unspecifiedVehicle and mobile equipment parts, n.e.c.
An employee was loading a telehandler onto a flatbed trailer. The employee stepped down 1 foot, trying to avoid mud, and stepped onto a grassy patch, then rolled his left ankle which was fractured and dislocated.
An employee was using an overhead crane to lift a 6-inch OD piece of round stock weighing approximately 617 pounds. He reached underneath the load to place a 1-foot block of wood when the load shifted and released from the rigging, landing on his hand. His left index finger was partially amputated to the knuckle.
On 12/22/2023, an employee was carrying bins filled with pasta to a refrigerator. As he lifted a 20-pound bin, he felt pain in his lower back. The employee sustained a herniated disc.
An employee was lifting a patient when they pulled a back muscle. She suffered back pain and spasms radiating into her leg with weakness and numbness. The employee's L3-L4 disc was herniated and she was hospitalized.
An employee was lifting a bundle of insulation with a colleague when he felt severe pain in the right side of his lower back/hip region. The employee sustained a severe muscle injury.
More severe injuries in this industry (NAICS 333120)
An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.
An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.
An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.
A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.