WMT Housing, LLC

An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.

An employee was moving a step ladder to a different location. A brad nail gun with an air hose attached was hanging on the side of the ladder. When the employee climbed the ladder, his right leg hit the safety tip of the nail gun and the nail gun shot a brad nail into the employee's right leg.

An employee was building walls for mobile home manufacturing using a 2 1/2 inch staple gun when the gun activated and a staple lodged into their right kneecap.

A forklift struck a bar under a bay door. The bar fell and struck an employee's head, breaking the employee's skull. The employee was hospitalized.

On May 27, 2022, at 2:30 p.m., an employee was descending a ladder while holding a nail gun when the nail gun discharged and a 2-inch nail entered the employee's upper-right abdomen, resulting in hospitalization.

An employee was making modifications to an electrical panel when an arc flash occurred. The employee suffered burns to multiple parts of the body.

An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.

An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.

On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.

An employee had just turned off breakers and was loosening wires on panels when they were shocked by 480 volts of electricity.

On September 5, 2025, an employee was installing gang plates on a structure when the side walls fell and hit her head. She then fell onto her back and the side wall pressed her to the ground, resulting in hospitalization due to an ilium fracture and a transverse process fracture on the right side.

An employee was blowing cellulose insulation into the open attic area of a manufactured home. While the employee was holding the insulation hose, it caught on the guardrail of the catwalk/suspended walkway leading into the attic. The tugging motion caused the employee to lose their footing and step onto the sheetrock ceiling. The employee fell through the ceiling to the ground about 8 feet below and suffered a broken lower left leg. The employee was hospitalized.

An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.

An employee was on a scaffold caulking and painting a manufactured home. She fell off the scaffold an estimated 6 to 8 feet, landing on the concrete floor. The employee suffered upper body injuries and was hospitalized.

An employee was going up a ladder from the first level roof to the second level roof. The ladder slipped and the employee fell approximately 8 to 10 feet to the surface on the first level. The employee sustained fractures to three ribs and bruises on their arms and hands.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.