Service Electric Company

Employee 1 had just finished disassembling a metal girder structure on the ground and had removed the bolts from its metal cross brace. Employee 1 then moved to the left side of the structure. Employee 2 was using a skid steer to pick up the metal cross brace. Once the cross brace was on the forks of the skid steer, employee 1's right leg was caught between the cross brace and the metal girder structure. Employee 1 was hospitalized with a fractured right leg, which required surgery to repair.

Employees were replacing an overhead utility line switch with a new set of switchgear. The injured employee was tightening a bolt to complete the last step of the work when an arc flash occurred and the employee was shocked.

Employees were in a mobile crane when it collapsed. They fell approximately100 feet to the ground and two employees were hospitalized. One employee sustained a hip injury and the other employee sustained a lung injury.

Employees were performing water-based excavation using a hydrovac truck. The stream of pressurized water lacerated an employee's left foot.

Employees were removing electrical cables for replacement. When one employee cut a cable, the employee was shocked in the abdominal area.

An employee was walking to their truck to look for a lid. When they stepped between the truck and a dock plate, they sustained a knee injury that required surgery.

An employee was standing on plant bed timbers, using a powered hand trimmer to trim the shrubs in the plant bed. The timber gave way, breaking into several pieces. The employee lost balance and fell with the trimmer in his hand. He suffered a severe laceration to the right wrist and hand.

A mail carrier slipped on ice and sustained a strain that required hospitalization.

An employee was loading phosphoric acid onto a rail car and preparing to secure the rail car for transport. While repositioning the loadout spout to secure it back to the drip pan holster on the dock, the spout contacted the handrail of the rail car, causing the employee to lose balance. The employee stepped back and their right foot entered the opening for the rail car, causing him to twist/pivot on his left leg. The employee's lower left leg was fractured.

On November 14, 2023, an employee was receiving a delivery from a truck when some of the merchandise fell from the truck s lift and struck him. He then fell to the ground and his head struck the sidewalk, resulting in an injury that required hospitalization.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.