Cactus Drilling Company LLC

An employee was watching the landing joint being lowered into the rotary table when it clipped the slip bowl, causing the slip bowl to flip over and strike the employee's legs. The employee's right femur was fractured and they sustained a fracture to the left leg below the knee. The employee was hospitalized.

A 5.5-inch production casing was being rolled. An employee was loading it onto a hydraulic catwalk when their left little fingertip was crushed between casing and the casing roller ramp. The fingertip was amputated behind the nailbed.

An employee was inspecting the liners of a mud pump that was making noise. The machine was shut down. As the pump was idling down, the inspection plate blew and knocked the employee back. Hot gear oil from the pump blew onto him, causing second-degree burns to his left arm and the left side of his face and ear. The employee was hospitalized.

An employee was pulling back a stand of heavy-weight drill pipe so it could be racked in the derrick. While the driller was slacking off with the top-drive, the injured employee unlatched the drill pipe elevators and pulled the pipe toward himself. The pipe came at him faster than expected and as he tried to get out of the way, the pipe hit his left ankle/leg and fractured the left tibia.

An employee pulled a stand of drill pipe back and had just finished pushing it back into a "finger" before securing it with rope. The driller was coming down with top drives and blocks. A gust of wind blew the employee's secondary retention into the Kelly hose clamp. As a result, the top drive pulled the cable and the employee down into the steel frame of the derrick board. The employee's left hip and right femur were fractured.

The employee was on top of a rail car to level the grain that was deposited into the car when they fell 13-15 feet to the ground. The employee sustained a right leg fracture.

An employee was on an extension ladder installing a satellite dish on a roof when they fell approximately 12-15 feet to the ground. The employee sustained fractures.

An employee was setting a 5-foot pry bar into a precast concrete slab and stood on the end of the pry bar to move the slab into place. The pry bar slipped out causing the employee to fall backward 15.5 feet to the dirt ground. The employee was hospitalized with a broken leg.

An employee was on a step ladder to measure and mark a crane rail for modification. The employee fell approximately 12 to 15 feet to the ground, resulting in a fractured right hip.

An employee was on a trailer securing a load of logs when they fell approximately 9-12 feet to the ground. The employee sustained brain hemorrhaging and lacerations to the thigh and above the eye. The employee was hospitalized.

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.