NEENAH FOUNDRY COMPANY

An employee was trying to unjam a tool. The employee's hand was caught between a conveyor and a belt, causing an injury that required hospitalization.

An employee was working with a manual core blowing machine with a sliding door. The platen came down on her finger, causing a partial amputation to the right thumb.

An employee was working on the melt deck in a foundry. The employee was chipping out a liner with a chip gun and replacing the lining in the spout when he felt dizzy and began to throw up on the floor. His condition worsened and he began sweating profusely and was not lucid. He was hospitalized with an acute kidney injury as the result of heat-related illness.

An employee was unloading a truck when he experienced pain. He was hospitalized with a hernia.

An employee was cutting pipe when they sustained a laceration to the face. The employee was hospitalized.

An employee suffered two fingertip amputations while working at a plant.

On September 25, 2023, an employee was working in the body department installing doors, hoods, and tailgates. The employee finished their shift and was hospitalized later that evening for a back injury.

An employee was operating a scissor lift and fractured their right ankle.

An employee was realigning two halves of a core box on a core-making machine. Pneumatic pressure released, causing the core box to close on the employee's right thumb. The thumb tip was amputated between the nail and the knuckle.

An employee was performing maintenance/electrical work inside a substation, and used a ladder to access the top of a panel box. The employee fell 8-9 feet from the top of the panel box to the ground. The employee was hospitalized with fractures to their ribs and a shoulder injury.

An employee's hand was caught in a pinch point in the area of a conveyor for a flask running out of a foundry molding machine. The employee's ring finger was crushed and partially amputated at the base.

An employee noticed a block was out of place under the weighted mold frame. The employee used another block to push the block out and replace it. When the block came out, the frame came down on his right ring and little fingers. The employee sustained a fracture and partial amputation to the ring fingertip.

An employee was using a fork truck to move a tub containing molten iron that had been drained from the cupula. The tub tipped over and the molten metal came in contact with water. This caused the molten iron to splash back and burn the employee's upper torso.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.