105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Dexter Axle Corporation, Plant #15

Struck by object falling from vehicle or machinery-other than vehicle part · Avulsions, enucleations

Federal OSHA recorded a severe workplace injury at Dexter Axle Corporation, Plant #15, 500 SE 27th St, EL RENO, OKLAHOMA 73036 on — Avulsions, enucleations, affecting the fingertip(s).

An employee was rotating an axle with a spreader bar that had hooks when the axle fell out of the hook and smashed the employee's finger between that axle and another axle. The employee's fingertip was de-gloved.

Hospitalized Fingertip(s) Vehicle and mobile equipment parts, n.e.c.

Star Pipe Products LTD

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

KP Building Products, Inc.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

BJ'S WHOLESALE CLUB, INC.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

International Steel and Counterweights LLC

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

Seneca Mechanical, LLC

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

ZF Chassis Systems Tuscaloosa, LLC

An employee had been utilizing a lift assist for assembly. When assembly was complete, the lift assist was hung on a rack behind the employee and it became energized because the trigger got caught. When the employee reached for the lift assist, it sprung up, striking their face. The employee was hospitalized with a facial fracture(s) and a concussion.

ATC Drivetrain, LLC

An employee inspected a machine to see if water leaking from the roof was affecting it and covered the machine with plastic. The employee was descending a 6-foot A-frame ladder when they slipped and fell to the ground from the third or fourth rung from the bottom. The employee sustained a fractured left humerus.

Borg Warner Transmission Products LLC

An employee was running a steel blanking press. After hearing a rattling noise in a conveyor belt that handled scrap coming out of the press, the employee went to clear a jam on the belt. The belt caught the employee's glove, and the employee's index and middle fingers were amputated.

ATC Drivetrain, LLC

An employee was operating a cone/spear punch press and went to remove a metal piece when the machine cycled. His thumb got caught between the cut rear section of the converter and the internal parts remaining inside and was crushed. The employee was hospitalized.

Alto Products Corp. AL

An employee was loading a coil of steel into the feeder for a 200-ton steel press when it actuated and his hand became caught in the feed rollers. The employee sustained lacerations and a fracture to his left forearm.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Meeco Sullivan

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

Edward Jones Investments

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

Burgess Manufacturing of Oklahoma Inc.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.