Al/Tex Homes, Inc.

An employee was sweeping behind a guardrail and stepped on the lower portion of the guardrail when he lost his balance. As he stepped back, his foot became stuck between the guardrail and a transformer, resulting in a compound fracture of left tibia and fibula.

An employee was repositioning a chill adder so that the pig tubs behind it could be removed. The employee lost their balance and their finger was pinched between the chill adder and the pig tub, resulting in a fingertip amputation.

An employee was backing up a stand-up forklift. The vehicle struck a guard and a wooden table. Upon exiting the forklift, the employee's left leg became caught between the table and dock guard, causing a fractured leg.

An employee was working on a shoring scaffold with another employee to strip plywood from cement. The employees threw a 4x4 piece of forming down and it got stuck on the beam of the scaffold. The injured employee went to grab the forming when their left ring fingertip was pinched between it and the beam, resulting in a partial amputation.

An employee was using a torch to trim the foundation for a compressed air tank so the tank would fit in place. His left hand was caught between the tank and the steel bar foundation structure; the hand was crushed and burned.

On September 5, 2025, an employee was installing gang plates on a structure when the side walls fell and hit her head. She then fell onto her back and the side wall pressed her to the ground, resulting in hospitalization due to an ilium fracture and a transverse process fracture on the right side.

An employee was blowing cellulose insulation into the open attic area of a manufactured home. While the employee was holding the insulation hose, it caught on the guardrail of the catwalk/suspended walkway leading into the attic. The tugging motion caused the employee to lose their footing and step onto the sheetrock ceiling. The employee fell through the ceiling to the ground about 8 feet below and suffered a broken lower left leg. The employee was hospitalized.

An employee was going between a ladder and a wall to repair a wall in the utility room. A brad-nailing gun was hanging on a piece of wood on the side of the ladder. The employee contacted the brad nailer and the trigger was pushed into the wooden piece. The brad-nailing gun actuated and shot a 2-inch brad into the employee's abdomen.

An employee was on a scaffold caulking and painting a manufactured home. She fell off the scaffold an estimated 6 to 8 feet, landing on the concrete floor. The employee suffered upper body injuries and was hospitalized.

An employee was going up a ladder from the first level roof to the second level roof. The ladder slipped and the employee fell approximately 8 to 10 feet to the surface on the first level. The employee sustained fractures to three ribs and bruises on their arms and hands.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.