Ignition of clothing from controlled heat source · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Mississippi Lime Company, 1715 Haining Rd , VICKSBURG, MISSISSIPPI 39183
on — Third or fourth degree heat (thermal) burns, affecting the multiple trunk locations.
Final narrative
An employee was in a truck bay, servicing 18-wheeler trucks. A propane heater ignited an oil rag on his clothes, causing third-degree burns on his front and back. He was hospitalized.
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 327410)
An employee was operating a compact open-cab skid steer. As he backed up, the skid steer's bucket lowered onto his leg, pinning it against the body of the skid steer. He was hospitalized, requiring surgery to the ankle/lower leg.
After driving and delivering product, an employee returned from a customer site and experienced cramps that did not go away. The employee was hospitalized due to dehydration.
An employee was standing on a transloader conveyor belt. He was in a crouched position attempting to remove a vibrator from the rail car. A coworker was with him, and as he was pushing the lever to turn off the vibrator, his hand hit the lever to engage the conveyor belt. The employee was spun around and caught under the guard and belt, breaking his left leg.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.