Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Falls Manufacturing Company/a U-Haul Co., 129 CANAL ROAD, FAIRLESS HILLS, PENNSYLVANIA 19030
on — Heat (thermal) burns, unspecified, affecting the shoulder(s) and back.
Final narrative
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
HospitalizedShoulder(s) and backClothing, unspecified
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
An employee was welding a kick bar onto the rear of a hopper on a trash truck. His clothing caught fire, resulting in second- and third-degree burns to his chest and stomach area.
More severe injuries in this industry (NAICS 336370)
An employee was verifying light curtain function at a load cell tester when their right index finger was amputated by a hydraulic cylinder above the middle knuckle.
An employee was positioning an overhead crane to stand up a skidded coil when the coil swung back. The employee was caught between the swinging coil and another coil sitting on a coil pad, resulting in hospitalization due to a loss of consciousness and a pelvic injury.
An employee was performing general cleanup duties when they collapsed and passed out due to heat exhaustion. They were hospitalized for heat exhaustion, dehydration, and acute renal failure.
A temporary employee was helping a forklift operator by holding metal sheets to steady them as they were placed on a rail for feeding to a stamp machine. The operator lowered the forks with the blanks (weighting approximately 750 pounds). The temporary employee's right index finger was caught between the metal and the feeding rail. The finger was crushed and partially amputated through the bone.
An employee was using a mechanical trim press to trim flash off metal parts. The employee was loading a part to be trimmed when the press cycled and crushed the index fingers on both of their hands. The employee sustained a fingertip amputation. The machine was not guarded at the time.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.