Prince Contracting, LLC.

A co-worker was adjusting an overhead bracket with an impact wrench when the tool flew out of their hand and struck the injured employee in the face. The injured employee sustained an injury to their left eye.

An employee was outdoors welding a template for copper piles. Around 4:00 PM, the employee experienced cramps and was hospitalized for heat stroke.

An employee used the ladder to go down into the 8 feet deep trench. He stepped onto the floor of the trench and started to sink. His co-worker dropped down an emergency retrieval sling and as he was pulling himself up with it, he hurt both legs resulting in torn ligaments.

An employee was fueling a crane. While climbing off the crane, he lost his footing and fell about a foot and a half striking the crane's tracks with his right leg below the knee. He suffered a laceration injury to the right leg and was hospitalized.

The employee was helping to secure a concrete wall panel that a backhoe was putting into place. The panel was secured and then the backhoe released the load, but the bottom of the panel came loose. The panel fell and struck the employee in the chest and left hand. The employee sustained broken ribs and abrasions on his hand.

An employee was drying and finishing vehicles when a vehicle door closed on their left middle fingertip and amputated it.

An employee was climbing down from a tractor trailer bed when they lost their footing and grabbed onto the roll-up door to stop the fall. The roll-up door then fell onto the employee's hand, resulting in a hand fracture that required surgery.

An employee was attempting to remove a tarp from a flatbed trailer when the trailer handle struck the employee in the chest, resulting in two broken ribs and a punctured lung.

An employee was near a backhoe while the operator was getting a broom. The broom handle struck the lever that actuates the swing of the backhoe bucket. The bucket then struck the injured employee, pinning him to the outrigger. The employee suffered crush injuries to the chest.

The injured employee was being trained on loading trucks in the load out bay. The injured employee and his supervisor climbed the stairs that run parallel to the truck and trailer, walked to the upper platform used for observation and sample taking, and saw that the lid of the grain trailer was closed. The employees began working to open the lid which appeared to be stuck due to cold weather. The injured employee pulled on one of the pivot arms that connect the lid to the main body of the trailer. As the lid began to open, the employee s right hand slipped down on the pivot arm and his index finger was caught between the pivot arm and the base of the pivot arm. The employee s right index finger was fractured and three nerves were severed. The employee was hospitalized.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.