Day and Zimmerman

An employee was climbing down a scaffold ladder when the employee's right foot slipped from the third rung from the bottom. The employee then fell to the ground, fracturing the left leg and requiring hospitalization.

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was using a chain fall to install a liner in a mill. As he was setting the liner in place, his right index finger got stuck in a chain on the rigging, resulting in a fingertip amputation that required hospitalization and a surgical reattachment.

An employee was descending a fixed 15-foot ladder. The employee slipped and fell, landing on a snubber machine 8 feet below and suffering a laceration to the left thigh and a fracture to the sternum.

An employee was walking to leave the worksite, slipped on mud, and fell to the ground. The employee suffered a C5 vertebra fracture that required surgery.

An employee was lowering himself on a scissor lift after inspecting a chain hoist. An auxiliary hoist being installed on the manipulator crane fell approximately 8 feet from its installed location and struck the employee in the upper back, fracturing two vertebrae.

An employee was assembling a pump with their left little finger positioned between the impeller and the discharge spacer. The element contacted the pump case's seating position and the shaft continued to move, pinching their fingertip between the two components. The employee sustained a fingertip amputation through part of the nail. The incident occurred during training.

An employee was working to remove a stuck strap from a tray line while on an A-frame ladder. They fell 6 to 8 feet to the concrete floor, resulting in a head contusion and fractured ribs that required hospitalization.

An employee sat on an unleveled bench outside the cafeteria and fell to the concrete. The employee was hospitalized with a head contusion with bleeding and injuries to the right side of her body, her right hip, and right hand, as well as a scrape to her elbow.

An employee was cutting brush and shrubs. A bee stung the employee on the base of their neck. The employee sustained an allergic reaction and was hospitalized.

A driver was exiting his truck and fell from the bottom step to the ground. He fell on the pavement on his left side, breaking his hip.

An employee was walking to his car when he tripped over a board that was secured to the floor of the dock area. His left knee struck the cement dock. The employee was hospitalized and required surgery to repair a broken knee.