EnerMech Mechanical Services

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

An employee was setting up for a door installation on a three-story building. The employee was moving an aluminum track frame from one condo to the condo next door by using the balcony when they misstepped and fell between balconies. The employee landed on the dirt below and suffered facial fractures.

An employee was replacing a fuel pump on a pickup truck using a transmission jack to lower the fuel tank from the vehicle. When he removed and lowered the tank, the tank caught fire, resulting in burns to his hands, arms, and legs.

An employee was removing concrete forms from a current pour when a form fell from the wall. An intact pin hooked the employee's safety vest and pulled them from the scaffold to the ground, resulting in a bruised chest (lungs).

An employee was driving a cement mixer. It flipped while turning a corner, and the cabin was flattened. The employee was pinned in the cabin and suffered a broken right hand, three broken ribs, and head lacerations.

An employee had attached a crane sling to an 8-inch pipe, and the crane was holding the pipe with minimal tension while bolts were removed from its lower flange. The pipe came loose and knocked the employee off the trailer to the ground 6 feet below. The back of the employee's head struck the trailer after the fall, causing a head injury.