Ignition of vapors, gases, or liquids · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Caribbean Auto Mart, 4523 Estate Charlotte Amalie, ST THOMAS, VIRGIN ISLANDS 00802
on — Heat (thermal) burns, unspecified, affecting the upper and lower limb(s).
Final narrative
An employee was replacing a fuel pump on a pickup truck using a transmission jack to lower the fuel tank from the vehicle. When he removed and lowered the tank, the tank caught fire, resulting in burns to his hands, arms, and legs.
HospitalizedUpper and lower limb(s)Gasoline, diesel fuel, jet fuel
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
An employee was working underneath a vehicle when the vehicle began to roll and a tire caught the employee's left ear. The employee sustained a laceration and partial amputation of their ear, requiring hospitalization and surgery to reattach the ear.
A car was being backed out of a bay so that another car could pull into it. The car's brakes did not respond, and the car reversed quickly. The injured employee approached the car to stop it, and it pinned his right leg against a lift. The employee was hospitalized.
An employee was exiting the company shuttle van when his shoe became caught on the door of the vehicle, causing him to fall out of the van to the ground. The employee was hospitalized with a fractured hip that required surgery.
An employee was working to change the tires and brakes on a vehicle. He pulled the vehicle out of the bay. The brakes failed, and the car drifted backward into another bay where it pinned the injured employee against the arm of a vehicle lift. The injured employee sustained seven fractured ribs on his left side.
An employee was setting up for a door installation on a three-story building. The employee was moving an aluminum track frame from one condo to the condo next door by using the balcony when they misstepped and fell between balconies. The employee landed on the dirt below and suffered facial fractures.
An employee was removing concrete forms from a current pour when a form fell from the wall. An intact pin hooked the employee's safety vest and pulled them from the scaffold to the ground, resulting in a bruised chest (lungs).
An employee was driving a cement mixer. It flipped while turning a corner, and the cabin was flattened. The employee was pinned in the cabin and suffered a broken right hand, three broken ribs, and head lacerations.
An employee had attached a crane sling to an 8-inch pipe, and the crane was holding the pipe with minimal tension while bolts were removed from its lower flange. The pipe came loose and knocked the employee off the trailer to the ground 6 feet below. The back of the employee's head struck the trailer after the fall, causing a head injury.
An employee was operating a bottle blow molding machine when he dropped his cell phone through the front opening of the machine. He activated the machine to move forward and attempted to retrieve his cell phone. While bending over, he touched the stop button, which caused the machine to reverse into the home position. The employee then became pinned when the panel moved into the home position, injuring his left arm and upper torso on the left side.