Struck by object falling from vehicle or machinery-other than vehicle part · Intracranial injuries, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Vivot Equipment Corporation, St. Croix Reinassance Park, CHRISTIANSTED, VIRGIN ISLANDS 00820
on — Intracranial injuries, unspecified, affecting the brain.
Final narrative
An employee had attached a crane sling to an 8-inch pipe, and the crane was holding the pipe with minimal tension while bolts were removed from its lower flange. The pipe came loose and knocked the employee off the trailer to the ground 6 feet below. The back of the employee's head struck the trailer after the fall, causing a head injury.
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 811310)
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was setting up for a door installation on a three-story building. The employee was moving an aluminum track frame from one condo to the condo next door by using the balcony when they misstepped and fell between balconies. The employee landed on the dirt below and suffered facial fractures.
An employee was replacing a fuel pump on a pickup truck using a transmission jack to lower the fuel tank from the vehicle. When he removed and lowered the tank, the tank caught fire, resulting in burns to his hands, arms, and legs.
An employee was removing concrete forms from a current pour when a form fell from the wall. An intact pin hooked the employee's safety vest and pulled them from the scaffold to the ground, resulting in a bruised chest (lungs).
An employee was driving a cement mixer. It flipped while turning a corner, and the cabin was flattened. The employee was pinned in the cabin and suffered a broken right hand, three broken ribs, and head lacerations.
An employee was operating a bottle blow molding machine when he dropped his cell phone through the front opening of the machine. He activated the machine to move forward and attempted to retrieve his cell phone. While bending over, he touched the stop button, which caused the machine to reverse into the home position. The employee then became pinned when the panel moved into the home position, injuring his left arm and upper torso on the left side.