Ignition of vapors, gases, or liquids · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Oil City Iron Works, Inc., 814 South Main, CORSICANA, TEXAS 75110
on — Second degree heat (thermal) burns, affecting the hand(s) and arm(s), unspecified.
Final narrative
An employee was filling a can with alcohol. The alcohol ignited and splashed onto the employee's hand and arm, igniting her clothing. She suffered second-degree burns to the hand and arm.
HospitalizedHand(s) and arm(s), unspecifiedAlcohols, unspecified
An employee was cleaning his work area and preparing it to begin making air-set molds
when a nearby forklift that was backing out from a load swung around and struck the employee. They sustained a lower left leg fracture.
An employee was moving a test bar containing iron that wasn't solidified. The test bar contacted the employee's right hand resulting in second and third degree burns to their hand, fingers, and wrist.
An employee was loading metals into a loader with a scrap crane when his right middle finger was caught between a crane magnet and the scrap metal and amputated.
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
An employee was realigning two halves of a core box on a core-making machine. Pneumatic pressure released, causing the core box to close on the employee's right thumb. The thumb tip was amputated between the nail and the knuckle.
An employee was performing maintenance/electrical work inside a substation, and used a ladder to access the top of a panel box. The employee fell 8-9 feet from the top of the panel box to the ground. The employee was hospitalized with fractures to their ribs and a shoulder injury.
An employee's hand was caught in a pinch point in the area of a conveyor for a flask running out of a foundry molding machine. The employee's ring finger was crushed and partially amputated at the base.
An employee noticed a block was out of place under the weighted mold frame. The employee used another block to push the block out and replace it. When the block came out, the frame came down on his right ring and little fingers. The employee sustained a fracture and partial amputation to the ring fingertip.
An employee was using a fork truck to move a tub containing molten iron that had been drained from the cupula. The tub tipped over and the molten metal came in contact with water. This caused the molten iron to splash back and burn the employee's upper torso.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.