Ignition of clothing from controlled heat source · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at GapVax, Inc., 575 Central Avenue, JOHNSTOWN, PENNSYLVANIA 15902
on — Third or fourth degree heat (thermal) burns, affecting the head, neck, and trunk.
Final narrative
An employee was welding when a spark landed on his shirt under his uniform and ignited both layers of clothing. He received first, second, and third degree burns to the upper torso, neck, and face.
HospitalizedHead, neck, and trunkBlouses, shirts, dresses, trousers, skirts
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 336211)
An employee was walking on a dock plate to open the door for the next trailer. He tripped on a cargo strap that was laying on the dock and fell. The employee sustained a fractured right hip, requiring hospitalization and surgery.
On September 18, 2025, an employee was rolling a stack of two steel racks containing automobile bumpers when the top rack dropped, pinching their right little finger. The employee suffered a partial amputation.
An employee was exiting an ambulance when his foot slipped, causing him to hit either the portable aluminum step or the concrete floor. He suffered a broken left elbow.
Two employees were sliding a 200-pound steel mounting plate off a worktable onto the forks of a forklift. They slid the plate until it was half on the table and half on the forklift, and were making an adjustment to get the plate fully on the forklift when the plate pinched one employee's left ring finger. He suffered a partial amputation to the fingertip.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.