MALVERN, ARKANSAS—
ACME BRICK
Caught in running equipment or machinery, unspecified · Fractures and dislocations
At a glance
Federal OSHA recorded a severe workplace injury at ACME BRICK, 22436 Hwy 67N, MALVERN, ARKANSAS 72104 on — Fractures and dislocations, affecting the shoulder(s) and arm(s).
Final narrative
A temporary employee cleaned a tripper and radioed the operator to restart the machine. The employee was then caught in a rotating shaft, suffering a left shoulder dislocation and left arm fracture that required hospitalization. The guard was removed at the time of the incident.
More severe injuries at ACME BRICK
MILLSAP, TEXAS—
ACME BRICK
An employee was removing a belt from a motor on an extruder when his finger was pinched by the belt, resulting in an amputation to the first knuckle.
MILLSAP, TEXAS—
ACME BRICK
An employee was attempting to align a brick in a strapping machine when the employee's fingers were caught in the machine, resulting in the removal of skin from two fingers.
CASTLE ROCK, COLORADO—
ACME BRICK
An employee was helping to move a pump assembly when the pump fell off the forklift and struck the employee breaking his pelvis.
ELGIN, TEXAS—
ACME BRICK
An employee was pulling bricks off of carts that were being moved forward by a forklift. The forklift operator moved the cart forward while the employee's hands were still on the brick, causing his right hand to smash against the metal surface and amputating his right thumb.
ELGIN, TEXAS—
ACME Brick
An employee suffered the amputation of the left index fingertip while troubleshooting a packaging machine.
View ACME BRICK's full OSHA safety record →
Similar incidents · Same event type
CULLODEN, WEST VIRGINIA—
Service Wire Company
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
OMAHA, NEBRASKA—
Oriental Trading Company, Inc.
An employee was examining a machine when a part moved up and amputated a fingertip on their left hand.
MCALLEN, TEXAS—
Fox Packaging
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
SALTILLO, MISSISSIPPI—
Ashley Furniture Industries, Inc.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
BEDFORD HEIGHTS, OHIO—
ITW Bedford Wire
An employee's right hand was caught in a wire drawing machine, resulting in amputation.
More severe injuries in this industry (NAICS 444190)
SOUTH SETAUKET, NEW YORK—
The Home Depot USA, Inc.
An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.
DENVER, COLORADO—
White Cap L.P.
An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.
GRAND ISLAND, NEBRASKA—
Builders Warehouse, Inc.
An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.
PERRYVILLE, MISSOURI—
Ready-Mix Concrete Incorporated
An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.
ROANOKE, TEXAS—
Texas Building Supply
An employee was operating a router when it cut his right little finger, causing an amputation through the bone.
More severe injuries in ARKANSAS
BLYTHEVILLE, ARKANSAS—
NATIONAL MILL MAINTENANCE, LLC
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
TEXARKANA, ARKANSAS—
The Goodyear Tire & Rubber Company
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
OSCEOLA, ARKANSAS—
Big River Steel, LLC
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
PINE BLUFF, ARKANSAS—
American Tile & Marble Co., Inc
An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.
SCRANTON, ARKANSAS—
Johnson Industrial Coatings, LLC.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.