Hol-Mac Corporation, Plant 2

An employee was placing a tube in a clamp for a drill press when the clamp closed on and crushed her lefty pinky finger.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was working in the shipping/receiving area on a packing paper dispenser that was jammed. When the paper came free, the blade pulled the paper in and pulled the employee's hand in too, amputating about a quarter of the right middle fingernail and the top of the finger.

On June 27, 2025, at approximately 7:00 PM, an employee was operating a cell that presses rings on a cylinder and welds the rings on. The cylinder was moving between the welding station and the press station when it fell off the holder. The employee went to place the cylinder back on the holder when the cell cycled and the compression holder crushed their right hand. The employee's middle, ring, and little fingers were crushed.

An employee was working on a hydraulic cylinder at his work table. While he was removing a bleeder plug to reduce the pressure, the 3/8-inch steel plug was pushed out by oil pressure. The plug impacted his wrist, causing an abrasion where hydraulic oil went into his arm. The employee was hospitalized.

An employee was pulling a steel cart backward when his left ring finger was crushed between the cart and another steel cart, resulting in amputation of the fingertip.

An employee was using a hydraulic press to repair a hydraulic tool that was stuck in the open position. Upon adding downward pressure from the hydraulic press, the tool's hydraulic quick coupler broke and released the ball bearing inside the coupler. The ball bearing struck the employee in the abdomen, resulting in lacerations and abrasions. The ball bearing also penetrated the employee's abdomen.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.