Titan International, Inc.

An employee was checking tank levels in the facility using a ladder. The employee fell off the ladder to the ground approximately 6-7 feet below and sustained a back injury.

An employee was cutting metal on a shear. His hand slipped and the shear amputated four of his fingers.

An employee was driving a forklift when it collided with another forklift. The employee's middle finger was pinched between the two forklifts and partially amputated.

An employee was operating an ATV when they were struck by a vehicle. The employee sustained multiple bruises and internal injuries.

A temporary employee was operating a powered industrial truck and attempting to maneuver around another automated powered industrial truck when the vehicles collided. The employee sustained a crush injury to their right foot.

An employee was operating a double pallet jack down an aisle when he was struck by another double pallet jack. The employee's right lower leg was then caught between the pallet jack and a rack beam, resulting in an injury just above the right ankle that required hospitalization.

An employee was operating a ride-on double pallet jack when he was struck from behind by another pallet jack. Their lower right leg was caught resulting in fractures to the tibia and fibula.

An employee was making repairs to a milling machine located in the mold shop. While using a screwdriver to make adjustments, the machine energized and struck the employee. The employee's right arm was fractured.

An employee was breaking down dunnage to prepare totes and trays to go through a tote washer. A tow motor driver asked the employee to move a cart that was in the way so the tow motor could remove a gaylord. The employee moved the cart and then stepped away from the tow motor. As the employee moved to an area between carts, his right foot got caught by a cart, causing him to twist and fall on top of a cart, landing on the left flank of his torso. The employee suffered a hemorrhage on his left flank.

An employee tripped over a computer cord and fell fracturing their femur.

Three employees were installing a transfer rail in a press. There were two employees holding the rail and the injured employee was at the end of the rail guiding the rail into the bracket. The task was done manually with no mechanical equipment. The employee had their finger at the end of the rail and went to make sure the rail was lined up while the other two employees pushed it into the bracket, causing their finger to become pinched between the rail and bracket. The employee's middle fingertip was amputated. Protective gloves were worn at the time of the incident.

An employee was walking across the dock, interacting with forklift drivers on what was being loaded. A forklift drove forward with a tall load on the forks. The employee was struck by the load (running board/rocker panel rack) on the forklift. The employee sustained several contusions and an injury to their right Achilles tendon that required surgery.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.