Direct exposure to electricity, greater than 220 volts · Second degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at North Houston Pole Line, 22275 Ford Road, PORTER, TEXAS 77365
on — Second degree electrical burns, affecting the nonclassifiable.
Watch North Houston Pole Line — freeGet an email when a new federal OSHA severe-injury report for North Houston Pole Line is published. One employer, no account, unsubscribe in one click.
Final narrative
The employee was working from a bucket truck transferring live wires from an old power pole to a new pole. The employee's lanyard got close enough to a live wire that an arc flash occurred. The employee sustained second degree burns where the metal parts of the harness contacted his body.
An employee was removing a staple from a wire conductor reel when the staple dislodged from the wood and struck the employee in the eye causing an eye injury.
An employee climbed a wooden pole to remove a downed conductor. The employee's right arm contacted the bottom of the energized switch and received third degree burns.
An employee was changing out the insulator on a buswork at a substation. An energized lightning arrester shocked the employee, causing burns to the left hand. The employee was hospitalized.
An employee was in an aerial lift preparing to install mechanical rigging onto a new power line when the fourth and fifth fingers of the employee's right hand were pinched and crushed between the aerial lift basket rail and the cross arm of the power line structure.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.