Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Comar, LLC, 1 Comar Place, BUENA, NEW JERSEY 08310
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was wiping grease off a machine with a paper towel. The towel got caught in the machine, pulling his hand in and partially amputating his right ring finger.
On October 14, 2025, an employee was on a step platform showing another employee the support bracket for a blow pin assembly on a blow molding machine that needed repaired. The blow pin assembly came up and pinched the injured employee's right middle finger, resulting in a broken finger and a laceration to the top of the hand.
An employee was using an overhead hoist to move an injection blow mold from a work bench to a pallet. The mold halves were being held together with a C-clamp. As the mold was being moved, it became entangled in the electrical cord for the hoist. The injured employee freed the mold from the electrical cord. The C-clamp then contacted the hoist beam supporting the leg and loosened, allowing the bottom half of the mold to fall. The mold struck the injured employee's left foot, lacerating it, fracturing the second metatarsal, and chipping the big toe bone. The employee was hospitalized.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 326199)
An employee was operating a drill and tap machine. He was placing a part with his right hand and removing a part coming in on the left side. He saw a part that was crooked and went to straighten it. The machine clamped down on his left index finger, degloving the top part of the finger and resulting in a partial amputation.
An employee was performing maintenance on a roll cutting machine in a warehouse. The employee was removing excess grease from the bearings when the machine's chain caught their right index finger. The fingertip was amputated by the chain and sprocket.
During fiberglass work, an employee mixed a methyl ethyl ketone peroxide (MEKP) catalyst with a cobalt chemical that they thought was a dye. A chemical reaction occurred, resulting in an explosion. The employee sustained second-degree burns on his back and a blister on his right arm.
An employee was walking when she tripped over a box on the ground and fell. The employee was hospitalized with a severe dislocation to the hip and leg that required surgery.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.