Caught in running equipment or machinery during maintenance, cleaning · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at Caterpillar Inc., 1720 W Kingsbury Street, SEGUIN, TEXAS 78155
on — Bruises, contusions, affecting the forearm(s).
Final narrative
An employee was adjusting a misaligned pallet on a conveyor system. The pallet return lift station rose up and pinched the employee's forearms against the frame of the machine. She suffered bruises and contusions on both forearms.
On September 13, 2025, an employee had been working at an outdoor event. At the end the day, she was walking around outside the facility to make sure everything was put away and felt overheated. The employee was hospitalized for heat-related illness.
On September 5, 2025, at approximately 7:35 AM, a temporary employee was at the engine block rollover machine. Their left index fingertip was caught and amputated between a pneumatic part and a guard.
On June 27, 2025, at approximately 8:35 AM, an employee was operating a box maker machine when their left middle fingertip was caught by a chain and sprocket. The employee's fingertip was partially amputated without loss of bone or the fingernail.
An employee had just put a dock plate in place. While stepping back over the plate, the employee tripped and fell onto it. The employee suffered a broken hip.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333120)
An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.
An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.
An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.
A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.