Direct exposure to electricity, greater than 220 volts · Second degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at Westrock CP, LLC, 1611 County Road 85, STEVENSON, ALABAMA 35772
on — Second degree electrical burns, affecting the hand(s), unspecified.
Final narrative
Employee 1 was replacing a bucket (480-volt breaker) while Employee 2 was observing from outside the arc flash boundary (36"). Employee 1 completed the work and was closing the door when an arc flash occurred. Employee 2 sustained first degree burns on the forehead and cheek and first and second degree burns to the hand. Employee 2 was hospitalized. Employee 1 was not injured.
An employee was quality checking a cutting device on a paper machine. As he went to manually rotate the flat outer surface of the band motor, his right index finger contacted the cutting side of one of the blades, resulting in a fingertip amputation. The machine blades were guarded at the time.
An employee was loading a 9,386-pound paper roll onto a peel station. The paper rolled off the station and the employee was caught between two rolls of paper, resulting in a pelvis fracture.
While conducting maintenance, an employee was feeding wire into a baler machine. As the employee was guiding the wire, the machine started; it broke and lacerated the employee's left arm.
An employee was threading a paper winder. When the paper curled, the employee tried to straighten the paper and contacted the paper slitter, resulting in a partial amputation to their right index fingertip.
An employee was loading a paper roll onto a machine using a pneumatic powered dolly. The employee's hand was caught between a stationary roll of paper on the floor and the roll of paper they were moving. The employee suffered an avulsion to the hand and was hospitalized.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee worked in the paper machine area for a shift, cutting corners off paper rolls around the roll machine. Afterwards, the employee sustained cramping and dehydration due to heat. The employee was hospitalized.
An employee was adjusting a trim sheet leading to a sheeter machine. Their glove became caught in the machine and the shearer closed on the employee's right hand, crushing it and breaking the hand and wrist.
An employee was troubleshooting a process upset. A nearby refiner had a pressure spike, causing the housing to separate slightly, which allowed the loss of primary containment. The employee was sprayed by hot water, resulting second- and third-degree burns on his torso and left arm.
On July 22, 2024, at 10:30 AM, an employee was responding to a pulp mill manufacturing process shutdown. Pulp stock overflowed through an engineered overflow pipe resulting in a buildup of stock in a bermed area. The stock was 140 to 150 degrees. The employee went to the bermed area to close an air-actuated process valve. While closing the valve, pulp stock entered the top of his boots and caused second-degree burns to both of his lower legs down to his feet. The employee was hospitalized.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.