Integro, LLC

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was working in the mixing department in an indoor warehouse when he began to sweat and cramp. He sustained heat exhaustion.

An employee was operating a rubber roller grinder and had just completed the grinding process. He changed the rotation of the spindle to the clockwise position and began to clean rubber dust off the rollers with a shop rag. The rag caught on the roller and pulled his hand into the grinding wheel, resulting in a broken wrist, broken fingers, and lacerations to the hand and fingers. He was hospitalized.

An employee was clearing jammed material from an extruder machine. The employee reached their left hand through the unguarded opening between the extruder machine and the conveyor belt to manually dislodge the jam and contacted the moving chain and sprockets, resulting in an amputation to the left thumb.

At about 10:05 a.m. on March 10, 2025, an employee was working at the loading side of a mix conveyor when his right wrist was caught in a pinch point between the conveyor and a roller. He suffered laceration and fracture injuries to the wrist and was hospitalized.

An employee was manually adjusting a mold on a shuttle plate when the mold shifted, resulting in amputation of his right middle fingertip.

An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.

An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.

An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.