Struck by falling object or equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Quad Graphics, Inc., 855 Caperton Boulevard, MARTINSBURG, WEST VIRGINIA 25403
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was helping to change out a cylinder on a press. He was putting the cylinder arms down to put the cylinder in place. As he stepped over the driveshaft to pull the pin and roll the cylinders, he lost balance and started to fall forward. He dropped the cylinder arm to regain his balance and the arm came down on his right index finger and amputated the fingertip.
AmputationFingertip(s)Machine and appliance parts, n.e.c.
An employee was trying to remove a blockage in a dust collection system. The airlock fan activated and amputated three fingertips on the employee's right hand.
An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.
Maintenance employees were replacing a gear box in the stacker of a press. After the replacement was complete, the stacker was restarted. The maintenance employees then heard a loud noise coming from the drive chain area and the injured employee went to check the chain tension when the machine amputated his right index fingertip.
While walking towards the office inside the warehouse, an employee slipped on a piece of debris (green strap) that was on the floor and fell. The employee sustained a fractured right hip.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
An employee was operating a press and manually feeding paper into the press when their right hand was caught in the press, resulting in several broken bones. The employee was hospitalized.
An employee was stepping off a forklift when they bumped the directional switch causing the forklift to roll forward and crush the employee's toe. The toe was partially amputated.
An employee was setting up a board-cutting machine when their right hand was caught in the machine. The employee sustained a crush injury to the hand that involved the tendons.
An employee was making routine adjustments to a machine when their left hand slipped and became caught in a gear. The employee's ring finger was partially amputated.
Employees were looking at an intake fan problem on a press. One employee was testing the tension on a belt when his right index finger was caught between the belt and the pulley. He suffered a partial amputation to the finger.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.