Quad/Graphics, Inc.

An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.

Maintenance employees were replacing a gear box in the stacker of a press. After the replacement was complete, the stacker was restarted. The maintenance employees then heard a loud noise coming from the drive chain area and the injured employee went to check the chain tension when the machine amputated his right index fingertip.

While walking towards the office inside the warehouse, an employee slipped on a piece of debris (green strap) that was on the floor and fell. The employee sustained a fractured right hip.

An employee was helping to change out a cylinder on a press. He was putting the cylinder arms down to put the cylinder in place. As he stepped over the driveshaft to pull the pin and roll the cylinders, he lost balance and started to fall forward. He dropped the cylinder arm to regain his balance and the arm came down on his right index finger and amputated the fingertip.

An employee was setting up a machine for a weekend run. The metal door closed on the employee's left index finger, causing a partial amputation.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

The injured employee's standup forklift had mechanical issue with a tire. The injured employee was inside their forklift to help steer it while it was being pushed up the ramp by another forklift. As the other forklift started to move up the ramp, it's forks moved and went into the driver's space of the disabled forklift. The fork penetrated the injured employee's left shoe, fracturing the two middle toes and injuring the first toe. The employee was hospitalized and required surgery.

A press was having a paster failure and the crew was working to get the ink on the paper. A press operator grounded himself and was entering the press unit when something flashed. The employee sustained third-degree burns to his head and left arm.

Around 12:45 PM, a clamp truck operator went to remove a piece of orange strap from a clamp truck that was parked outside of the office. The strap fell into a gap between the frame and the hood of the truck. The strap became caught in the engine's fan and also wrapped around the employee's hand when he went to grab it. The strap was pulled tight against the frame of the clamp truck, causing lacerations and fractures to the employee's hand. The employee was hospitalized and required surgery.

At 12:00 p.m. on August 13, 2025, an employee was unloading a 1,100-pound roll of paper from a skid when the roll fell onto his right leg. The leg was broken.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.