Struck by swinging or slipping object, other than handheld, n.e.c. · Open wounds, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at NATIONAL WEATHER SERVICE, 119 Dallas Hwy SW, CARTERSVILLE, GEORGIA 30120
on — Open wounds, unspecified, affecting the head, unspecified.
Final narrative
An employee was removing weights from the base of a sensor wind tower. The tower tilted and struck the employee, causing a head injury that required staples.
HospitalizedHead, unspecifiedTools, instruments, and equipment, n.e.c.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 541620)
The employee was working in the back of a micro truck and maneuvering around the materials in the back of the truck. The employee's foot caught on the edge of the truck, causing him to lose balance and fall from the back of the truck to the ground approximately 3.5 to 4 feet below. The employee landed on his feet on the loading dock but rolled his ankle. The employee was hospitalized with a compound fracture of the ankle.
An employee was assisting the operator of a soil sampling rig to collect soil samples. He went to remove soil sampling tooling and the energized equipment cycled. His right index fingertip was amputated including the fingernail.
A truck driver was loading a second roll-off container onto a two-box trailer. He was operating the hydraulic control levers with his left hand, and was holding the D-ring in place on the exterior of the trailer while letting slack out of the winch cable. The employee's right little finger became pinched between the winch cable and the structure of the trailer. The employee required surgical amputation of the distal phalanx.
An employee was sampling a fluid catalytic cracking (FCC) unit by opening a valve and placing a proving tube inside to collect the sample. The sample taken is a hot gas mixture. When the sample was collected, the flange came undone and fell due to the pressure. The employee sustained an amputation to their right middle fingertip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.